VAUTID 40

VAUTID 40

For impact loads and moderate abrasion

In impact load situations, it is important that the armored overlay is malleable and capable of being formed. This allows the kinetic energy of striking particles to be absorbed and, ideally, to be released again. VAUTID 40 meets this challenge in full. With its ductile matrix, this alloy offers exceptional protection against shock loadings, yet still contains a sufficient quantity of hard particles to provide moderate protection against abrasion as well.

It can even be machined after tempering, making this alloy particularly well-suited for the production of close-tolerance components. Very good results can also be achieved in metal-on-metal wear applications.

Recommended applications:

  • Components which are subject to both impact and abrasion, in applications where impact stresses are the major consideration, e.g. hammers for crushing plants handling moderately abrasive media.
  • Components which need to be machined after hard-facing.
  • Metal-on-metal wear applications, e.g. guides and rails.
Alloy
Typical microstructure VAUTID 40

Carbides
Chromium carbides Cr7C3 2200 HV1

Typical microstructure VAUTID 40
1 Carbide hardness is specified in the [HV] unit (Vickers hardness).

Downloads

pdf, 712.22 KB

VAUTID material profile:
VAUTID ASW Auftragschweißwerkstoffe/Hardfacing welding consumables
VAUTID Hardfacing welding consumables
VAUTID material profile

Expert advice

For comprehensive technical advice with a personal touch, get in touch with VAUTID:

Sales Austria and Hungary
Phone: +43 7243 520 91 – 0
austria@vautid-group.com

Sales Europe
Phone: +49 711 4404 – 403
europe@vautid-group.com